11 Steps to Spray Paint Your Car Like the Professionals - Car Bodywork Paint Repair

You may be surprised to find just the way to spray on auto paint actually can not be difficult. That doesn't mean that you go at it and can simply grab a tin of paint. There are some basics you have to understand. Both in the preparation and application.

Step A:

Prepare by gathering all of your items that you're going to need.

Measure B:

You may need to examine the car carefully. These will have to be sanded with 300 grit sand paper. In addition, it enables the spray automobile paint to stick better. Once you have finished sanding, be sure all the dust dirt and debris are removed from the vehicle. It is critical the car be absolutely clean.

Step C:

You will need to apply a primer. This will make sure you get an overall even coating of your colored paint plus helps the paint to stick well. Be sure to apply light layers and allow for drying in between when you spray the primer. The way to spray auto paint requires a little getting used to.

Step D:

Now you're pretty well to the point where you happen to be about ready to spray on the shade. In either case, make a couple of practice strokes on an object before you start with the auto. Once you might be ready, begin the passes with the paint without reluctance. If you hold the spray can or gun in one place, you will end up with coverage that is uneven and potentially the paint will run. If this happens you have a significant repair job on your had. You will most probably have instructions regarding the best way to spray auto paint using the spray or gear cans.

Step E:

You may want to study this option on the internet, or check with someone that's comfortable with the way to spray on auto paint

Step F:

Once you are thoroughly Alloy Wheel Repair Harold Hill satisfied with the color, you're down to the finishing touches. You may now need to apply several coatings that are clear. This will give the shine and finished appearance to the auto together with protect the finish. Likely two layers will be satisfactory but it's going to be up to you personally. Make absolutely certain it truly is dry in between coats.

Step G:

Once again, you've the choice of wet sanding if you favor. Again, I will suggest you request the guidance of people that are familiar with how to paint a car. You need to wet sand with the following grits in this order if you decide to follow this step then. This will remove spots that'll not be too light in the clear coat application.

Step H:

Step I:

You should buff the surface. To try this just use a medium cut polish.

Step J:



As a final touch, you might want to apply a few coats of wax.

Write a comment

Comments: 0